Triumph Bobber Forum banner
1 - 20 of 29 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #12 ·
I don't know how to meassure either. If it is inner or outer diameter?

Also inches is not my preffered way of meassuring anything.

I want a black one. Might spray paint a silver one from ebay black.
 

·
Premium Member
Joined
·
1,689 Posts
I don't know how to meassure either. If it is inner or outer diameter?

Also inches is not my preffered way of meassuring anything.

I want a black one. Might spray paint a silver one from ebay black.
I just ordered this one...

5-3/4? Headlight Visor | 3100280 | J&P Cycles

I'll let you know how it turns....and yes, painting may be in order. I couldn't fine any other brass ones...and not to keen on "chrome" for this.
 

·
Premium Member
Joined
·
1,689 Posts
you take off the bezel/head light rim (small screw at the bottom) that is at the front of the headlight. The visor rests on top of the glass, put the bezel/headlight rim over it to sandwich between the light and the rim, then tighten the screw on the bottom.

I'm not 100% sure that this will fit well or not, it's universal, but for less than $20 shipped, figured I'd give it a shot.
 

·
Registered
Joined
·
76 Posts
Discussion Starter · #18 ·
Nope. I just have to attack it with primer and spray paint I guess.

I do got "mercury black" on spray cans. That is the outboards. Nice black color. Think I will try that.
 
1 - 20 of 29 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top