Rear wheel
1 - 7 of 7 Posts
Joined
·
209 Posts
If I'm gonna go the route of changing rear sprocket it's gonna be for a belt drive set up.
Joined
·
1,065 Posts
Dunno about that. Trirocket did a great job of his chain guard. I'd need to see a shot of the whole bike to judge the impact of the painted chainguard.
Joined
·
360 Posts
I recently fitted a gold coloured chain on mine too:wink2:
mike
mike
Attachments
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
What did you do to your Triumph Bonneville Bobber today?
What did you do to your Triumph Bonneville Bobber?Share what you have done recently with the Bonneville Bobber forum community! Example: I took her out of the garage and gave her a nice bath and followed up with a coat of wax. Example: Finally received my slash pipes, going to spend sometime with the install. Example: Installed my custom...- 1K
- 127K
-
Administrator · updated
-
Baak front signal bracket
What did you do to your Triumph Bonneville Bobber?With just the bracket on it's own my signals were vibrating like mad. I added some rubber door stoppers for kitchen cupboards..no more shaking. I was concerned that they would melt, but they seem fine.- 1
- 55
-
Beaker · updated
-
Final Version of Sprung Seat
What did you do to your Triumph Bonneville Bobber?I’ve completed the final version of my seat upgrade. I ended up using 5” springs mounted to some right angle brackets. The seat is from La Rosa, one of their off the shelf seats as opposed to the specific bobber ones. The seat can move up and down so it’s very comfortable, particularly on...- 29
- 4K
-
b_gilbert1 · updated
-
TEC front fork progressive spring upgrade
What did you do to your Triumph Bonneville Bobber?Hi everyone - have recently had OEC front fork springs (linear) replaced with TEC progressive springs. Report : definite and substantial improvement, virtually no dive on firm/hard breaking, probably smoother ride over uneven surfaces. Impression - definitely worthwhile.:laugh:- 11
- 1K
-
Greybeard · updated
-
Tank to tail bag.
What did you do to your Triumph Bonneville Bobber?Hello folks, thought I'd share a little project I've been working on to find a solution to mounting a Triumph tank bag to my rack. After a lot of thought I've finally come up with this design which seems to work well. Basically, I cut and shaped two stainless steel sheets which sandwich the bag...- 2
- 131
-
daggartuk · updated
Join now to ask and comment!