Triumph Bobber Forum banner
1 - 1 of 1 Posts

89 Posts
Discussion Starter · #1 ·
Went for a nice ride in the local mountains today. When I got home, I noticed the wire cover for the Multifunction Lamp Kit had broken off. Looking closely, I see the screws are still in place and chucks of the cover's plastic threads are still attached.

I'm a geek about torque specifications so I know the cover wasn't under or over tightened. Seems the plastic just gave way. It's very hot here today, very near 100 f. I wonder if the mixture of heat and California's horrible roads was too much for the plastic to withstand?

Anyone else had this problem?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.