Triumph Bobber Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I'm looking to fit slightly higher bars on my Bobber, without the expense of changing the cables and plumbing. I thought I might try a set of standard bonneville bars, they seem to be about 3 inches higher which might be a problem, but they are a bit narrower which might just enable the original wiring/plumbing etc to fit. Has anyone any experience of this?
 

·
Registered
Joined
·
509 Posts
After doing the high bar job , I would have serious doubts about anything other than a 1" riser fitting with the stock set up. They were stingy in this area.
 
1 - 6 of 6 Posts
Top