he tail tidy has arrived from France. Initial response is positive. It is nicely cut and formed.
The disappointing part is that the web page claims that the fitting is completely reversible which I suppose it is as far as mechanical fitting goes. There are no instructions which is fair enough, so I contacted them and asked how they had resolved the wiring. The response was - "Sorry, we do not have more documents/infos than what is on the site, this is a new product just launched and we still need to do a proper set of instructions (when we get a bike and the time to do so...)
We are also trying to get a "plug&play" connecting loom but this will take a while.
In other words, they have only bolted it onto a Bobber but not wired it.
This means that I have to resolve the wiring myself. I am a resourceful bloke but just a bit miffed, expecting to fit this easily.
So, how to make connections to the loom and then enclose them. I want to keep the original pin ends on the loom so maybe buy a Bobber (light side) socket or simliar from somewhere and refit with my wires so that I can plug into the original socket on the bike.
Then how to enclose that and hide it.
I have Rizoma rears to fit. Gees - do I need the resistors as well? Maybe I need a pannier to put the wiring in
More to think about!